Gas Connection; Fuel Bed And Log Installation - Cannon CANTIB User Instructions

Gas connection

Fuel bed and log
installation
15. Connect incoming gas supply pipe to regulator. For inlet posi-
tion see figure 19. Close gate over gas supply and seal around
the pipe with fibreglass insulation material. Sealing is impor-
tant as it prevents leakage from fan chamber into chimney:
also check for gas soundness.
19
16. The fuel bed is contained within the burner chamber. Remove
the fuel bed transit packaging. Refer figure 20.
The fuel bed is retained by a spring clip fixed to the rear of the
burner chamber
FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER.
20
17. Carefully unpack the log set. Logs are numbered as follows:
No 1 - Left front log
No 2 - left back log
No 3 - Right front log
No 4 - Right back log
Position the four individually numbered logs in the following
order on the fuel bed as shown in figure 21-24. The male
locating pins in fuel bed must engage with corresponding
holes in the individual logs.
a) Place log No.1 onto the 2 front left pins on the fuel bed,
see figure 21.
21
13