Standards - Cannon CANTIB User Instructions

Standards

9. For installation into a non-combustible fireplace, ie: masonry
or brick or into a mock fireplace, i.e. timber or plasterboard,
the chimney and base should be of sound construction and be
free from cracks and holes (to ensure that sufficient flue draught
can be generated).
NOTE: WHEN INSTALLING INTO A MOCK FIREPLACE A
MOCK FIREPLACE HEATER MUST BE USED.
Mock fireplace model no's: CANTIBM & CANTIBMLP.
10. The heater must be properly installed in a working chimney or
connected to a venting system. Operation of this heater, when
not connected into a working chimney or a properly installed
and maintained venting system can result in carbon monoxide
(CO) poisoning and possible death.
11. The appliance should be inspected prior to use, with regular
inspections (annually) to be made by a licensed service per-
son. It is important that circulating air passageways of the
appliance be kept clean, dirt and lint free, for a safe and
efficient operation of the heater.
12. On first lighting your heater a smell may occur due to it's new
condition. This is quite normal and will disappear after a few
hours use at the maximum control position.
Important:
WHEN THIS HEATER IS OPERATING, THE GLASS FRONT IS HOT.
A safety guard conforming to AGA requirements is available for
this heater. It is an optional extra, which may be fitted to the heater
to reduce the risk of fire or injury from burns. Its fitting is recom-
mended when there are children present. For permanent protection
of young children or the infirm, an optional mesh guard is recom-
mended. Call your retailer or authorised service agent for further
details.
This appliance meets the following standards:
Standards Australia: AS 3100
AS 5601/AG 601
AS 4553/AG 103
5