Table of Contents
Advertisement
Installation instructions continued
Sealing
12
11. Remove the inner glass. Slacken off screws in top clamp and
remove side clamps. Refer figure 16.
16
12. All gaps between heater case and fireplace are to be sealed.
Seal with foam tape around top and sides of heater flange as
required. Refer figure 17a.
Seal with fibreglass between bottom of heater case and base
of fireplace.
17a
13. Slide heater into the fireplace ensuring that gas inlet pipe is fed
through the hole at the rear bottom RHS of the heater. Refer
figure 18 and gas connection figure 19.
-
18
14. With heater in position, flanges should be hard against 7asonry.
Secure case flanges to the masonry. Refer figure 16b.
17b
Advertisement
Table of Contents
