Restore Configuration; Software Upgrade - Planet GRT-101 User Manual

PLANET Technology Corp. GRT-101/401/402 User's Manual
your terminal access program or Telnet program to save it to a text file. Don't
miss any script command line, or you would loss part of the configuration.
Note: With "show script" command, the password is printed with "*" instead of the real password characters for security.
Therefore, the backup configuration does not contain the password information. Remember to recover correct
password information manually after the backup procedure by a text editor. There is no command that could show the
password information. You should save your password in a safe place for any eventuality.

3.17.2 Restore configuration

Before you restore the old configuration back to GRT-101/GRT-401/GRT-402,
make sure to clear the whole setting back to the factory defaults first with the
following command:
admin# setup default
Are you sure? (y/n): y
Set OK!
admin#
To restore the configuration, copy the content of the whole configuration file,
which was saved according to section 3.17.1 Backup configuration, and paste
them into the console CLI via your Telnet program or terminal access program.
Watch the system messages to ensure every command was accepted by the
system successfully.
Note: The Telnet program is recommended during backup process. If only the serial port could be used, carefully add
some delay by adjust the line and/or character delay for your terminal access program so that all command could be
accepted by the system without error. Also, the configuration file backup with "show script" command has the
password printed with "*" instead of the real password characters for security. Therefore, remember to recover correct
password information manually before the restore procedure.
To save your restored configuration and let it take effect, enter:
admin# write
and reboot the system.

3.18 Software Upgrade

You check the software version of GRT-101/GRT-401/GRT-402 by the
command:
admin# show system
- - 67