Chapter 3 Configuration; Purpose; Logon Procedure; Serial Console - Planet GRT-101 User Manual

3.1 Purpose

This chapter provides information about configuring GRT series.
After you have completed all the necessary settings for GRT series, make sure to
write the new configuration to NVRAM by "write" command and reboot the
system, or all of your changes will not take effect.

3.2 Logon Procedure

There are three methods to logon to GRT series: serial console, Telnet, and web interface. For
the first-time configuration, perhaps only the serial console mode could be used because
applications requiring Internet protocol (IP) communication, such as Telnet and web interface,
are not available unless a management IP is configured properly for your local networking
environment.
After connecting all the necessary cables described in 1.3 , power on GRT series and select
one of the following procedures to access GRT series.
It is recommended that only one configuration application is used to set up GRT
series at any given time, that is, Telnet, serial console and the web management
interfaces should not be used simultaneously.

3.2.1 Serial console

Check the connectivity of the RS-232 cable from your computer to the serial port of GRT series.
Start your terminal access program with VT100 terminal emulation. Configure the serial link
with baud rate of 9600, 8 data bits, no parity check, 1 stop bit, and no flow-control, and press
the SPACE key until the login screen appears. When you see the login screen, you can logon
to GRT series.
User: admin
Password: *****
If you have not set any user profile for GRT series, enter the factory default user
"admin". When the system prompts you for a password, type "admin" to enter
GRT series.

Chapter 3 Configuration

- - 15
G.SHDSL Bridge/Router
GRT-101/401/402 User's Manual