PLANET Technology Corp.
GRT-101/401/402 User's Manual
3.9 Connection Mode
GRT-101/GRT-401/GRT-402 supports two connection modes: bridging and
routing. Currently, it comes pre-configured with routing mode. Note that,
routing mode and bridging mode cannot be used simultaneously.
To let GRT-101/GRT-401/GRT-402 operate in bridging mode, type:
admin# setup mode bridge
To save changes enter:
admin# write
To enable your changes, reboot the system:
admin# reboot
To set GRT-101/GRT-401/GRT-402 operating in routing mode, enter:
admin# setup mode route
To save your changes enter:
admin# write
To enable your changes, reboot the system:
admin# reboot
3.10 Bridging Mode
Note: This section is for bridging mode operation only.
When GRT-101/GRT-401/GRT-402 operates in bridging mode, it behaves like
a wire connecting a local PC directly to a service provider's network. Bridge
data is encapsulated using the RFC1483 protocol to enable data transport.
GRT-101/GRT-401/GRT-402 currently supports IEEE 802.1D transparent
learning bridge.
3.10.1 Bridge management
You can manage GRT-101/GRT-401/GRT-402 using Telnet either from LAN
- -
46