Command Line Interface - Planet GRT-101 User Manual

PLANET Technology Corp. GRT-101/401/402 User's Manual

3.4 Command Line Interface

For serial console and Telnet management, GRT-101/GRT-401/GRT-402
implements two operational interfaces: command line interface (CLI) and
menu driven interface. The CLI mode provides users a simple interface, which
is better for working with script file. The menu driven interface is a user-friendly
interface to general operations. The command syntax for CLI is the same as
that of the menu driven interface. The only difference is that the menu driven
interface shows you all of available commands for you to select. You don't
need to remember the command syntax and save your time on typing the
whole command line.
The following figure gives you an example of the menu driven interface. In the
menu, you scroll up/down by pressing key I / K, select one command by key L,
and go back to a higher level of menu by key J. For example, to show the
system information, just logon to GRT-101/GRT-401/GRT-402, move down the
cursor by pressing key K twice and select "show" command by key L, you shall
see a submenu and select "system" command in this submenu, then the
system will show you the general information.
In this chapter, all configuration procedures are explained by command line
examples with necessary parameters. When operating in the menu driven
interface, just select the corresponding command items from the menu
hierarchy to configure the same setting.
- - 30