Isp Profile For Ppp - Planet GRT-101 User Manual

PLANET Technology Corp. GRT-101/401/402 User's Manual
WAN 6 Disable
WAN 7 Disable
WAN 8 Disable
To save the new WAN port configuration, enter:
admin# write

3.12.5 ISP profile for PPP

Note: This sub-section is for routing mode operation only.
If your local ISP uses protocols of "PPPoA" or "PPPoE" over the ATM VC, you
may need to setup the username and password information provided from
your local ISP. The maximum length of username and password for ISP
setting is limited to 51. The following command configures the ISP profile for
WAN 3 with username "pppoa3@isp.com", password "Fuyg47ds", and idle
timeout of 10 minutes:
admin# setup wan 3 isp pppoa3@isp.com Fuyg47ds 10
To review the new configuration you have configured, type:
admin# setup wan 3 list
Int. ISP account username Idle time
---- --------------------------------- ---------
WAN 1
WAN 2
WAN 3 pppoa3@isp.com 10
WAN 4
WAN 5
WAN 6
WAN 7
WAN 8
Note: The ISP account information would not be shown if the corresponding WAN port is disabled. The account
information is provided from your local ISP. Please ask your local ISP if you do not know the username and password.
The "PPPoA" and "PPPoE" protocols are designed based on the concept of
"dial-on-demand". Each time a request is made from a host on the LAN,
GRT-101/GRT-401/GRT-402 checks the link status of the WAN ports and
transfers the packets if the link status is active. When the link status is not
- - 59