Chapter 3 Configuration; Purpose; Logon Procedure; Serial Console - Planet GRT-101 User Manual

PLANET Technology Corp. GRT-101/401/402 User's Manual

Chapter 3 Configuration

3.1 Purpose

This chapter provides information about configuring
GRT-101/GRT-401/GRT-402.
Note: After you have completed all necessary setting for GRT-101/GRT-401/GRT-402, make sure to write the new
configuration to NVRAM by "write" command and reboot the system, or all of your changes will not take effect.

3.2 Logon Procedure

There are three methods to logon to GRT-101/GRT-401/GRT-402: serial
console, Telnet, and web interface. For the first time configuration, perhaps
only the serial console mode could be used because applications requiring
Internet protocol (IP) communication, such as Telnet and web interface, are not
available unless a management IP is configured properly for your local
networking environment.
After connecting all the necessary cables described in Chapter 2 Installation,
power on GRT-101/GRT-401/GRT-402 and select one of the following
procedures to access GRT-101/GRT-401/GRT-402.
Note: It is recommended that only one configuration application is used to setup GRT-101/GRT-401/GRT-402 at any
given time, that is, Telnet, serial console and the web management interfaces should not be used simultaneously.

3.2.1 Serial console

Check the connectivity of the RS-232 cable from your computer to the serial
port of GRT-101/GRT-401/GRT-402. Start your terminal access program with
VT100 terminal emulation. Configure the serial link with baudrate of 9600, 8
data bits, no parity check, 1 stop bit, and no flow-control, and press the
SPACE key until the login screen appears. When you see the login screen,
you can logon to GRT-101/GRT-401/GRT-402.
User: admin
Password: *****
Note: If you have not set any user profile for GRT-101/GRT-401/GRT-402, enter the factory default user "admin".
When the system prompts you for a password, type "admin" to enter GRT-101/GRT-401/GRT-402.
- - 8