Security; Snmp; Supervisor Password And Id - Planet GRT-101 User Manual

PLANET Technology Corp.
port or telent in user profile table however users who have the supervisor
password can change the configuration of GRT-101/GRT-401/GRT-402. Move
the cursor " >> " to user and press enter key.
>> clear
modify
list
You can delete the user by number using clear command. If you do not make
sure the number of user, you can use list command to check it. Modify
command is to modify an old user information or add a new user to user
profile.

3.5.2 Security

Security command can be configured ten legal IP address for telnet access
and port number.
Move the cursor " >> " to security and press enter. The default legal address
is 0.0.0.0. It means that there is no restriction of IP to access
GRT-101/GRT-401/GRT-402 via telnet.
>> port
ip_pool
list

3.5.3 SNMP

Simple Network Management Protocol (SNMP) is the protocol not only
governing network management, but also the monitoring of network devices
and their functions. GRT-101/GRT-401/GRT-402 can generate SNMP traps to
indicate alarm conditions, and it relies on SNMP community strings to
implement SNMP security. This router support MIB II.
Move the cursor " >> " to snmp and press enter.
>> community
trap

3.5.4 Supervisor Password and ID

The supervisor password and ID are the last door for security but the most
important. Users who access GRT-101/GRT-401/GRT-402 via web browser,
console port or telnet have to use the ID and password to configure
GRT-101/GRT-401/GRT-402. Suggest to change the ID and password.
Clear user profile
Modify the user profile
List the user profile
Configure telent TCP port
Legal address IP address pool
Show security profile
Configure community parameter
Configure trap host parameter
GRT-101/401/402 User's Manual
- - 40