PLANET Technology Corp.
3.8.4 Bridge
You can setup the bridge parameters in bridge command. If the product is
configured as a router, you do not want to setup the bridge parameters. Move
the cursor " >> " to bridge and press enter.
>> gateway
static
You can setup default gateway IP via gateway command.
You can setup 20 sets of static bridge in static command.
3.8.5 Route
You can setup the routing parameters in route command. If the product is
configured as a bridge, you do not want to setup the route parameters. Move
the cursor " >> " to route and press enter.
>> static
RIP
You can setup 20 sets of static route in static command.
3.8.6 LAN
>> address
attrib
3.8.7 IP share
>> nat
pat
dmz
For more NAT, PAT and DMZ information, review NAT/DMZ section.
Default gateway
Static bridging table
Configure static routing table
Configure RIP tool
LAN IP address and subnet mask
NAT network type
Configure network address translation
Configure port address translation
Configure DMZ host function
GRT-101/401/402 User's Manual
- -
44