Wan - Planet GRT-101 User Manual

PLANET Technology Corp.
GRT-402's link type will be 2-wire or 4-wire mode according to the product.
4-wire product can be worked under 2-wire mode.
You can setup the data rate by the multiple of 64Kbps- n is from 0 to 32. If you
configure n is 0, the product will perform as adaptive mode.
There are two types of SHDSL Annex type, Annex-A and Annex-B.
Clear command can clear CRC error count.
Generally, you cannot need to change SNR margin, which range is from 0 to
10.

3.8.3 WAN

GRT-101/GRT-401/GRT-402 supports up to 8 PVC, private virtual circuit, and
so you can setup eight WAN, WAN1 to WAN8. Move the cursor " >> " to wan
and press enter. To setup WAN1, type 1.
---------------------------------------------------------------------
Command: setup wan <1~8>
Message: Please input the following information.
Interface number <1~8>: 1
---------------------------------------------------------------------
>> protocol
address
vpi_vci
encap
qos
isp
list
There are four types of protocols, IPoA, EoA, PPPoA and PPPoE, which is
supported by your ISP.
For PPPoA and PPPoE, you do not need to setup IP address and subnet
mask.
There is an unique VPI and VCI value for Internet connection supported by ISP.
The range of VIP is from 0 to 255 and VCI from 0 to 65535.
There are two types of encapsulation types, VC-Mux and LLC.
You can setup virtual circuit quality of service, VC QoS, using qos command.
There are two QoS class, UBR and CBR. The peak cell rate can be configured
from 64kbps to 2400kbps.
ISP command can configure account name, password and idle time. Idle time
are from 0 minute to 300 minutes.
You can review the WAN interface configuration via list command.
Link type protocol
IP address and subnet mask
Configure VPI/VCI value
Configure encapsulation type
Configure VC QoS
Configure account name, password and idle time
WAN interface configuration
GRT-101/401/402 User's Manual
- - 43