Table of Contents
Advertisement
This chapter will show you how to configure the basic functions of your CPE within minutes.
A computer with wired Ethernet connection to the Wireless CPE is required for the first-time
configuration.
Manual Network Setup -- TCP/IP Configuration
The default IP address of the WBS-512AC is 192.168.1.253. And the default Subnet Mask is 255.255.255.0.
These values can be changed as you want. In this guide, we use all the default values for description.
Connect the WBS-512AC with your PC by an Ethernet cable plugging in LAN port on one side and in LAN port
of PC on the other side. Please power on the WBS-512AC by PoE switch through the PoE port.
In the following sections, we'll introduce how to install and configure the TCP/IP correctly in Windows 10. And
the procedures in other operating systems are similar. First, make sure your Ethernet Adapter is working, and
refer to the Ethernet adapter manual if needed.
4.1.1 Configuring the IP Address Manually
Summary:
Set up the TCP/IP Protocol for your PC.
Configure the network parameters. The IP address is 192.168.1.xxx (If the default IP address of the
WBS-512AC is 192.168.1.253, and the DSL router is 192.168.1.254, the "xxx" can be configured to any
number from 1 to 252.) and subnet mask is 255.255.255.0.
1
Select Use the following IP address, and then configure the IP address of the PC.
2
For example, as the default IP address of the WBS-512AC is 192.168.1.253 and the DSL router is
192.168.1.254, you may choose from 192.168.1.1 to 192.168.1.252.
Chapter 4. Quick Installation Guide
-14-
User Manual of WBS-512AC
Advertisement
Table of Contents
