Planet GRT-101 User Manual page 60

PLANET Technology Corp. GRT-101/401/402 User's Manual
admin# setup shdsl mode STU-R
To set the SHDSL operation mode to STU-C, enter:
admin# setup shdsl mode STU-C
To set link type to 4 wire, enter:
Only GRT-402 support 4 wire phone line to connect, it also allow to assign link
type by actually connection type.
admin# setup shdsl link 4-Wire
To set link type to 2 wire, enter:
admin# setup shdsl link 2-Wire
Also, GRT-101/GRT-401/GRT-402 allows you to assign the connection rate
directly by setting the N parameter of "n*64" command:
admin# setup shdsl n*64 <0~36>
where "0" indicates that the adaptive mode will be used to automatically train
up to the ideal line speed. The other valid value of N parameter ranges
between 3 and 36. Do not set the N value to 1 or 2. For example, to configure
the SHDSL physical layer data rate to 256kbps, enter:
admin# setup shdsl n*64 4
For different region, you might need to set up the SHDSL type to be "Annex_A"
or "Annex_B" by the following command:
admin# setup shdsl type Annex_B
Note that, to let your setting take effect, you have to save your changes and
reboot the system by enter:
admin# write
- - 55