System Status And Performance - Planet GRT-101 User Manual

PLANET Technology Corp.
active, it performs login procedure with the account information of ISP profiles
and then transfers the packets if login successfully. Once the link has been
established successfully, GRT-101/GRT-401/GRT-402 continuously monitors
the traffic over WAN links. The "PPPoA" or "PPPoE" section will be cut off if
there are no packets over the links during the period of idle timeout. The valid
value for idle timeout is from 0 to 300 minutes. The idle timeout of "0" means
that the session connects always even there is no traffic over the WAN link. To
save the new WAN port configuration, enter:
admin# write
Note: Currently, the section timeout is set to be 10 minutes. Also, WAN 1 has the highest priority to dial if multiple WAN
ports are enabled with PPPoA/PPPoE protocols while WAN 8 has the lowest one. In most applications,
PPPoA/PPPoE protocols must work with NAT/PAT. Please refer to section 3.11.3 NAT/PAT for details.

3.13 System Status and Performance

Use the "status" command to display GRT-101/GRT-401/GRT-402 activities.
To see a list of applications and interfaces that provide status, enter:
admin# status ?
shdsl <CR>
wan <CR>
route <CR>
To display specific information, for example, for the SHDSL interface status
and performance, enter:
admin# status shdsl
<SHDSL Status>
SHDSL mode
Bitrate
Tx Power
Current SNR Margin
Attenuation
CRC Error Count
SHDSL Remote Side Status
Current SNR margin
Attenuation
Show SHDSL status
Show WAN interface status
Show routing table
:SHDSL CPE Side
:512kbps
:13.5dBm
:10.8dB
:35.8dB
:0
:10dB
:35dB
- - 60
GRT-101/401/402 User's Manual