For Diseqc 1.2 Receiver - Strong DiSEqC Positioner v50 User Manaul

Restore Factory Default (Reset):
This function will clear all data in the Positioner, includes High/Low Limits, Satellite Positions, ..., etc.
1. Unplug from the AC outlet. Press the Power button on the top of the positioner and
re-plug to the AC outlet. Keep pressing the Power button for 3 seconds. The Display will
show 10, 9 ... 1, then reset the system. To stop the Reset process, unplug from the AC
outlet before counting to 1.
2. Keep pressing the "Reset" button on the remote control until the positioner finishes
counting down from 10 to 1. To stop the Reset process, simply stop pressing the Reset
button before the positioner counts down to 1.
If reset has been successfully completed, it will show " æ æ æ " on the LED. After 2
seconds, it shows 000. (count number 1000).

7.0 FOR DISEQC 1.2 RECEIVER

The denomination of some commands might be different, but similar. Please refer to the manual of
the Receiver.
Set the Software High / Low Limits:
After sending the commands from the DiSEqC 1.2 receiver, the Display of the positioner will show as below:
North Hemisphere
South Hemisphere
Cancel the Software High / Low Limits:
After sending the command from the DiSEqC 1.2 receiver, the Display of the positioner will show "LoF".
8
Lock
After 2 Seconds
Low Limit
Low Limit
East Limit
West Limit
Enter
West Limit
East Limit
PART 1 • English
High Limit
High Limit