Strong DiSEqC Positioner v50 User Manaul page 11

the Display will show "Er2" first then "000" which indicates the mechanical 0 position of
the Actuator.
Restore Factory Default (Reset):
This function will clear all data in the Positioner, includes High/Low Limits, Satellite Positions, ..., etc.
Unplug from the AC outlet. Press the Power button on the top of the positioner and re-plug to the AC
outlet. Keep pressing the Power button for 3 seconds. The Display will show 10, 9 ... 1, then reset the
system. To stop the Reset process, unplug from the AC outlet before counting to 1.
For DiSEqC 1.0 Receiver
1. For DiSEqC 1.0 Receivers, they can control up to 4 positions.
Position
LNB
LNB
The table is for your reference only. The operation might be different for different
receivers. For example, some receivers call position 1 ~ 4 as LNB1, 2, 3, 4 or DiSEqC A,
B, C, D. Please refer to the manual of your receivers.
2. In order to avoid confusion, the positioner will ignore the DiSEqC 1.0 commands after
receive the DiSEqC 1.2 commands. It can recognize the DiSEqC 1.0 commands again
after unplug from AC for more than 5 seconds.
3. The optional Remote Control is not necessary for DiSEqC 1.0 receivers. However, the
optional Remote Control is strongly recommended for the following reasons: 1) Easier
Operation. 2) More positions (from 4 to 60).
The following is the operation without remote control. If you have the optional remote control, please
refer to chapter For any Receiver
Store the Satellite Positions: Operate via the 3 Manual buttons
1. Drive the Actuator East / West via the manual East / West until the picture on the TV
screen is clear.
2. Press the Power / Store button for 5 seconds, the LED will show "C01".
3. Press Up / Down buttons to choose the sat. no. you want to store: C01 ~ C60.
4. Press Store button for confirmation within 3 seconds, the LED will show P01 ~ P60.
10
1 2
1 2
A B
PART 1 • English
3 4
3 4
C D