For Any Receiver - Strong DiSEqC Positioner v50 User Manaul

6.0 FOR ANY RECEIVER

Optional Remote Control is necessary
Set the Software High / Low Limits:
Setting the software High / Low Limits are recommended for better protection even if there are
Hardware Limit Switches on the actuator or H-H mount. However, the Positioner can be operated
without setting the software High/Low Limits.
1. Drive the Actuator by pressing East / West button to the intended lowest / highest
position. P.s. For North Hemisphere, the Low limit means East Limit. For South
Hemisphere, the Low Limit means West Limit.
2. Prod Limit button on the remote control. The Display will show L_ _.
3. Press East or West button within 3 seconds. The Display will show L.L. or H.L. Press
Enter button within 3 seconds.
Cancel the Software High / Low Limits:
Prod the Limit button on the remote control twice, the display will show "L_ _" first then flashy
"LoF", press the Enter button within 4 seconds to cancel the limits.
Store the Satellite Positions:
1. Drive the Actuator or H-H mount East / West until the picture on the TV screen is clear.
2. Press Store button on the remote control. The Display will show "C_ _".
3. Press no. buttons "1 ~ 60" the display will show "C01 ~ C60".
4. Press Enter button, the display will show "P01 ~ P60".
5. Repeat Step 1 to 4 to set up all the satellites you prefer.
6
PART 1 • English
Enter
Enter