Table of Contents
Advertisement
10. Default Settings
10.1. Set Default Interface
Scan the following menu barcodes to return to the default settings.
There are two ways to configure factory default settings:
•
One-by-one configuration by scanning the Code 39 menu labels below.
Note: When duplicated scanning of a menu label occurs, the last label scanned will
take effect.
•
Multi-configuration by scanning the QR code menu label below.
Default Settings
10.1.1.
Code 39 Menu Labels for One-by-One Configuration
ZZ
C02
ZZ
10.2. Configuring Settings by Reading Menu Barcode Labels
Communication parameter settings for the OPI 4002 can be configured by scanning
menu labels.
Refer to the instruction manual for further information about menu labels.
Address Registration to Connect with OPA 1001
10.2.1.
Read an address barcode printed on the label attached to the OPA 1001 cradle.
Confirm that the OPA 1001 is connected to the OPI 4002
Note: Scanned data cannot be transmitted unless the address registration is
completed.
Wireless Communication Channel Settings: CH11–CH26
10.2.2.
The wireless communication channel settings can be adjusted.
Data Memorizing Settings Outside the Communication Range:
10.2.3.
DTME/DTMD
Selecting "Data Memorizing Enabled" allows the scanner to read data outside the
communication range and store the data in OPI 4002 memory. When the scanner
Set
Interface Settings
IEEE802.15.4 HID Data Transmission
End
[[
D13
[[
18
Opticon
OPI 4002
Specifications Manual
QR Code Label for
Multi-Configuration
Advertisement
Table of Contents
