Optical Specifications; Laser Scan Specifications; Laser Scan Standards; Laser Scan Tilt - Opticon OPR 3101 Specification Manual

6. Optical Specifications

6.1. Laser Scan Specifications

Parameter
Light-emitting element
Emission wavelength
Light output
Scanning method
Scanning speed
Scan angle
Auto-trigger IR detection area
Notes:
Refer to chapter 14, "Trigger and Read Options," to read about the scan modes.
Refer to chapter 7, "Technical Specifications," to read about scanning performance.

6.2. Laser Scan Standards

Laser Scan Tilt

6.2.1.
Laser scanning tilt is the vertical difference between both ends of a laser scan
line. Measure it in the middle of the laser scan line.
•
Less than 1.2° angle in vertical direction from the scan origin (mirror motor).
•
Up to 3.1 mm when measured at a point 150 mm from the scan origin. (The
skew angle of this measurement was 0°.)

Curvature of Scan

6.2.2.
The maximum difference between the laser scan line and the line between both
ends of the laser scan line. Measure it in the middle of the laser scan line.
•
Up to 1.27° angle in vertical direction from the scan origin (mirror motor).
•
Up to 3.3 mm curvature when measured at a point 150 mm away from the
scan origin.
Specification
Red laser diode
650 ±10 (25° C)
1.0 or less
Bi-directional scanning
100 ±20
Scan angle: 54 ±5
Read angle: 44 (Min)
40
13
OPR 3101
Specifications Manual
Unit
—
nm
mW
—
scans/s
°
°
mm
Opticon