Table of Contents
Advertisement
5. Electrical Specifications
Power of DC 5V-10% to DC6V+10% is supplied to the scanner.
(*1)
OPTOELECTRONICS does not guarantee any troubles or scanner malfunctions caused by the use of the
AC adapters which are not provided by OPTOELECTRONICS.
Item
Power supply voltage
In-rush Current
Operating Current
Stand-by Current
Start-up Time
Conditions:
• Connect 1 ohm resistance to a power supply line in series and measure the current by the
voltage between both ends of resistance.
• Power supply voltage is measured at a connector terminal area.
(*2)
If the current value does not get stable within 1.5 seconds after activating the polygon mirror, this
scanner detects the system error and stop the polygon mirror and blinks green and red LEDs.
6. Optical Specifications
Item
Light-emitted element
Emission wavelength
Light output
Scan method
Scan rate
Scan angle
Effective scan angle
Vertical scan width of
NLB-1000 (single scan)
Vertical scan width of
RLB-1000 (raster scan)
Mark
Min.
Typ.
Max.
VDD
4.5
6.0
Ipeak
-
2000
Iop
-
205
IPRE
-
145
Td
-
Specification
Red laser diode
650±10 (at 25 degrees C)
1.0 or less
Octahedron polygon mirror
1000±60 (at 25 degrees C)
70° (typical)
40° (typical)
Less than 8
(500 mm from the front face of the scanner)
8 to 20
(500 mm from the front face of the scanner)
9
Specifications Manual
(*1)
Unit
6.6
V
mA
500
mA
Laser OFF, Polygon mirror ON
mA
Scans at a rate of 800
scans/sec to 1200 scans/sec
1.5
sec
carried out within 1.5 seconds
after the polygon mirror gets
(*2)
activated.
NLB / RLB-1000
Notes
LED OFF
Unit
nm
mW
scan/sec
deg
deg
mm
mm
Advertisement
Table of Contents
