Image Is Blurred Or Stained; Print Density Is Uneven - Xerox WorkCentre 6400V/S User Manual

Troubleshooting

Image is Blurred or Stained

Probable Causes
One or more of the imaging units may be defective.
One or more of the toner cartridges may be defective.
The two grey dials on the fuser are adjusted for
envelope printing.

Print Density is Uneven

Probable Causes
One or more of the toner cartridges may be defective
or low.
One or more of the imaging units may be defective.
The printer is not level.
The grey dials on the fuser are set for envelope
printing.
Specialty paper in use.
206 WorkCentre 6400 Multifunction Printer
User Guide
Solutions
Remove the imaging units one at a time, and check
for damage. If it is damaged, replace it.
Remove the toner cartridges and check each for
damage. If one or more is damaged, replace it.
Rotate both grey dials on the fuser to the paper
setting.
Solutions
Remove the toner cartridges and check for damage.
If it is damaged, replace it.
Remove the imaging units one at a time, and check
for damage. If it is damaged, replace it.
Place the printer on a flat, hard, level surface.
Rotate both grey dials on the fuser to the paper
setting.
Perform the "Calibrate Paper Type" calibration in the
Tools/Calibration menu.