First Entry Power-Up And Configuration; Procedure 1: First-Time Power-Up - Polycom RMX 2000 Getting Started Manual

Chapter 2-First Time Installation and Configuration

First Entry Power-up and Configuration

Preparations
Hardware
Installation
and
Setup
First Entry
Power-up and
Configuration

Procedure 1: First-time Power-up

2-14
There are four procedures necessary for setup of the new RMX. It is
important that they are performed in the following sequence:
1
First-time Power-up
2
Product Registration.
3
Connection to MCU.
4
Modifying the Default IP and ISDN/PSTN Service Settings (Fast
Configuration Wizard).
To power-up for the first time using the USB key:
1
Insert the USB key containing the modified IP addresses in USB port
on the RMX's back panel.
2
Power the RMX On.
AC System - Turn ON the power by pressing on the power switch
located on the rear panel of the RMX 4000.
DC System - Turn ON the Main that supplies power to the RMX and
then turn ON each of the DC power entry modules.