Ip Network Services Required Information - Polycom RMX 2000 Getting Started Manual

IP Network Services Required Information

When installing an RMX unit, these default IP addresses must be
modified to your local network settings. Therefore it is important that
before powering the RMX unit up for the first time, that you obtain the
information needed to complete the Local Network Settings section of
the table from your network administrator. The network administrator
should allocate four IP addresses in the local network for an MCU with
one MPM card and five IP addresses for an MCU with two MPM cards.
Table 2-1 Network Equipment and Address Information
Parameter
Control Unit
IP Address
Control Unit
Subnet Mask
Default Router IP
Address
Shelf Management
IP Address
Signaling Host IP
address
Media Board IP
address (MPM 1)
Media Board IP
address (MPM 2)
Media Board IP
address (MPM 3)
RMX 4000 only
Media Board IP
address (MPM 4)
RMX 4000 only
Gatekeeper IP
address (optional)
Polycom RMX 2000/4000 Getting Started Guide
Factory Default
192.168.1.254
255.255.255.0
192.168.1.1
192.168.1.252
–
–
–
–
–
–
Local Network Settings
2-3