Figure 2-1, Remote Cut-Out Dimensions; Figure 2-2, Remote Control Connections - Magnum Energy ME-RC Owner's Manual

Figure 2-1, Remote Cut-Out Dimensions

Info: All power to operate the remote control is provided by the
inverter/charger through the remote cable.
6. While monitoring the front of the remote, connect the other end of the cable
into the RJ11 jack on the back-side of the remote (see figure 2-2).
7. Immediately upon connecting the remote cable, all the LED's will come on
as the unit goes through a self-test. After the initial self-test completes, text
should appear with a system status message indicating the current state of
the inverter/charger. If not, please refer to the troubleshooting section.
8. Secure the remote to the wall using the four 6 x 3/4" screws provided.
9. The remote is ready for set-up.
M agnum Inverter

Figure 2-2, Remote Control Connections

©2009 Magnum Energy Inc.
5 "
1/4
C U T O U T T H IS
A R E A
(d ia g ra m n o t to sca le )
4 "
7/8
Rem ote cable
REM O TE Port
(blue label )
2.0 Installation
RJ 11 connection
3