Magnum Energy ME-RC Owner's Manual page 19

• SETUP: 0 Power Saver - This setting allows you to turn off the
Power Saver™ feature or select the time (from 1 minute to 60 minutes) that
determines how often the display goes into Power Saver mode.
Default setting: PwrSave = 15min
SETU P
Status...
07 Power Save
press
Status...
PwrSave = Off
Figure 3-12, SETUP: 07 Power Saver Selections
What is the power saver feature? The Power Saver feature causes the
LCD backlight and LED's on the remote display to turn off to conserve energy.
The remote goes into Power Saver mode if there hasn't been a pushbutton
press or fault message for a period of time (this time is determined by the
SETUP: 07 Power Save setting). Whenever the remote goes into the Power
Saver mode, the LCD backlight and LED's can be reactivated by pressing
any menu pushbutton. If you have a fault during the Power Saver mode, the
LCD backlight and Fault LED will come on and stay on as long as the fault is
detected.
If you want the LCD backlight and LED's to always be on, you will need to
turn the Power Saver feature off by selecting PwrSave = Off.
• SETUP: 0 Screen Setup - Used to adjust the contrast of the LCD
screen and backlight brightness for the best looking display based on the
current lighting conditions and viewing angle.
Default settings: Contrast = 100%; Brightness = 50%
SETU P
Status...
08 Screen Setup
press
Status ...
Contrast = 0%
Status...
Brightness= 50%
Status ...
Brightness= 0%
Figure 3-13, SETUP: 08 Screen Setup Selections
©2009 Magnum Energy Inc.
rotate to
press to select
Status...
PwrSave = 1min
rotate to
press to select
Status ...
.......
Contrast = 50%
rotate to
desired
selection :
Status ...
.......
Brightness= 50%
rotate to
desired
selection :
Status ...
... ...
PwrSave = 15min
rotate to
desired
selection :
Status...
.......
Contrast = 90%
press to save
Status...
.......
Brightness= 90%
3.0 Setup
press to save
Status...
PwrSave = 60min
press to save
Status...
Contrast = 100%
Status...
Brightness=100%
5