3.0 Setup
3.2.5 TECH Menu
The TECH menu pushbutton provides access to selections that are used to
assist service technicians in troubleshooting. It provides access to system in-
formation along with a selection that allows all system settings to be returned
to the original factory default values.
TECH: 0 Temperatures – This "read only" menu displays temperature read-
ings of the battery temperature sensor (if connected), the transformer, the FET's
(Field Effect Transistors) and a networked AGS (if installed).
TEC H
press
Status ...
BTS: **C/**F
Figure 3-14, TECH: 01 Temperatures Display
TECH: 02 Revisions – This "read only" menu displays the firmware revision
level of the inverter, remote and any optional accessory (i.e. AGS) that is
installed and networked.
TEC H
press
Status ...
Inverter: **
Figure 3-15, TECH: 02 Revisions Display
TECH: 03 Inv Model – This "read only" menu displays the model number of
the connected inverter.
TEC H
press
Status...
03 Inv Model
Figure 3-16, TECH: 03 Inv Model Display
Info: When "Model: UNKNOWN" is displayed, the remote is not able to
determine the inverter model, this is due to an older inverter model or
an inverter revision newer than the remote; all remote menu selections
and features that are available in the inverter will function normally.
rotate to
Status...
01 Temperatures
Status...
Tfmer: **C/**F
rotate to
Status...
02 Revisions
Status...
Remote: **
rotate to
press to select
Status ...
Status ...
FETs: **C/**F
AGS: **C/**F
press to select
Status ...
Status...
AGS: **
BMK: **
display show s
Status...
press
Model: ****
©2009 Magnum Energy Inc.
rotate to
desired
display :
rotate to
desired
display :
connected
inverter: