Assembly - MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY

ASSEMBLY:

Follow the assembly instructions to prepare your MK-370 EXP for operation.
1. Cutting Head Installation:
NOTE: If the Cutting Head is installed, go to step 2.
Flat Washer
(A)
Place the Flat Washer onto
the Height Adjusting Knob
2. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not "cross-thread" and DO OT over tighten the screw.
(A)
Loosen and remove the Blade
Guard, Retaining Knob
(B)
Align Cutting Head Pivot Hole
to the Post, Pivot Shaft
(D)
Install the Height Adjusting
Knob through the Post into the
Cutting Head and tighten the
Knob
(B)
Loosen the Blade Guard,
Retaining Wing nut
1
(C)
Verify the Cutting Head is
completely installed and
seated on the Post
(C)
Open the Blade Guard