MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 24

SETUP, ADJUSTMENT & OPERATION
4. Off-angle Cutting:
NOTE: Use a Protractor (MK Part No. 134569-MK) to cut angles other than 45º angles. (not included)
CAUTION
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
Adjustable
cutting guide
(A)
Remove the Adjustable
Cutting Guide
(D)
Tighten the Protractor Gage
retaining knob
(G)
Position the tile against the
Protractor and the Ruler/Stop
Ruler/Stop
Place the Protractor on the
Desired cut length
indicated here
Position the Protractor Cutting
Guide to the desired length
(G)
Perform the cut
Turn CCW to
loosen
(B)
Ruler/Stop
(E)
(H)
Turn the motor ON
Turn the motor OFF when
work is complete
2
(C)
Set the desired angle on the
Protractor Gage
(F)
Tighten the retaining knob
(I)
Verify cooling flow on both
sides of the blade
(H)