MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 39

"Rodding" cooling channels is performed by inserting a small wire rod through the cooling inlet on top
NOTE:
of the Blade Guard and directing the rod out through each of the cooling flow tubes located on the
underside of
foreign debris.
Rod Cooling Channels and
4. Blade Stops Turning
GFCI
(A)
Verify all plugs are fully
installed
(D)
Verify circuit breaker not
tripped If tripped, reset once
MAINTENANCE AND TROUBLESHOOTING
the Blade Guard. The cooling channels should be "rodded" until all ports are free of
(K)
recheck flow
Check to see if the Ground
Fault Circuit Interrupter (GFCI)
Check power source voltage
is 115V – if not 115v, move to
another circuit
Return to MK Diamond
for Repair
(B)
is tripped
(E)

(L)
(C)
Verify circuit breaker at least
20 amps – if not, move to
20-amp circuit
(L)
Return to MK Diamond
for Repair