Alignment - MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions

MAINTENANCE AND TROUBLESHOOTING

ALIGNMENT:

The Movable Cutting Table of the MK-770 is pre-aligned in the factory. It may become misaligned with the
Cutting Head of the Tile Saw over time. Should misalignment occur, perform the following steps to realign it.
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if
alignment is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594
1/2-inch Wrench
(A)
Remove Tile Saw
from Power Source
Combination Square
12-inch or Greater
1/4-inch Wrench
(B)
Inspect Tile Saw
for damage
2
Flat Head Screwdriver
(C)
Inspect Diamond Blade
for damage