MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 36

MAINTENANCE AND TROUBLESHOOTING
45° Alignment Verification:
The 45° Alignment Verification is done to ensure the blade will cut tile at a 45° angle.
NOTES: If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for
repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
Blade Guard retaining
(A)
Remove Blade Guard
(If not done Previously)
No Gaps between
Blade and Square
(D)
Verify Blade is even
across all points of Square
Rotate Knob Counter-
clockwise to loosen
wing nut
Position the Cutting Head
to the 45° Cutting Angle
To Adjust 45° Cutting Angle,
No Gaps between
Blade and Square
(G)
Verify Blade is now even
across all points of Square
(B)
Upper
Screw
(E)
locate the 45°
Adjustment Screw
Repeat steps A to G until Blade
is even across all points of

(C)
Place Square on the Movable
Cutting Table and position the
Square against the Blade
(F)
Rotate 45° Adjustment Screw
clockwise or counter-clockwise
to realign 45° Cutting Angle
(H)
Square
Square