MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 34

MAINTENANCE AND TROUBLESHOOTING
Alignment Screw, 90° Verification:
90º-alignment verification will ensure that the blade will cut the tile straight up and down and not at an angle.
NOTES: If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for
repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
Rotate Knob Counter-
clockwise to loosen
(A)
Position the Cutting Head
to the 45° Cutting Angle
(D)
Position the Square on
Movable Cutting Table
against the Diamond Blade
Lower
Screw
(B)
Locate the 90°
Adjustment Screw
No gaps between
Blade and Square
(E)
Verify the Diamond Blade
is Square to the Movable
Cutting Table

(C)
Rotate 90° Adjustment Screw
clockwise or counter-clockwise
to realign Cutting Head
(F)
Repeat Steps A to E as
necessary to align the
Cutting Head