MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 33

MOVABLE CUTTING TABLE ALIGNMENT VERIFICATION:
This will verify the Movable Cutting Table is aligned to the frame of the saw.
NOTES: If the blade is misaligned following alignment verification, attempt to align using Alignment Screw, 90º
Verification. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
Blade Guard retaining
wing nut
(A)
Remove Blade Guard
(D)
Move Square to wheel
assembly side of the cutting
table
(G)
Move Wheel Assembly up or
down to Square the Movable
Cutting Table
MAINTENANCE AND TROUBLESHOOTING
Flat Surface
(B)
Place Square on guide bar
side of cutting table
(E)
Verify Wheel Assembly side of
Movable Cutting Table height
is same as Guide Bar side
(H)
Check that there is no gap
between the Square and the
wheel assembly side of frame

Lock in position
If Gap exists, loosen Movable
Cutting Table Wheel Assembly
Square
No Gap
Tighten Movable Cutting
Table Wheel Assembly
Lock
(C)
(F)
(I)