MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 19

4. MK-370 EXP Setup for Operation
CAUTION
1. Before powering or starting, check for damage that could prevent this equipment from
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-370 EXP to a power supply, be sure the voltage, cycle and
VOLTAGE
CYCLE
PHASE
4. Use an approved Ground Fault Circuit Interrupter (GFCI)
5. Do not cover the motor vents as this could lead to motor overheating.
1. In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
NOTE:
2. If using an extension power cord, make sure the length and wire gauge correspond to he
requirements listed in TABLE 1 on page 9. An extension power cord that is too small in wire gauge
(diameter), or too long in length, will cause the motor to overheat and could cause premature failure.
(A)
Ensure the ON/OFF Switch is
in the OFF position
SETUP, ADJUSTMENT & OPERATION
proper operation or performing it's intended function. Check for binding and
alignment of moving parts. Check for damaged, broken, or missing parts.
phase of the job site power source meet the requirements of TABLE 3
TABLE 3
GFCI
Plug MK-370 EXP into the
115V
60Hz
1-phase
(B)
GFCI
1
(C)
Plug the GFCI into the Power
source