MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions page 16

UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
3. Adjustable Cutting Guide Installation:
NOTE: The Adjustable Cutting Guide can be used on either side of the Diamond Blade.
Loosen Adjustable Cutting Guide
retaining thumbscrew and place it over
the Movable Cutting Table, Ruler/Stop
4. Splash Guard Installation
Install the retaining thumbscrew
through the washer and Splash
Guard then align to the hole found on
back of the Blade Guard
5. Water Pump Preparation:
(A)
Install Water Pump
Discharge Fitting
(A)
(A)
Press one end of the Cooling
Transfer Tube onto the Water
Pump Discharge Fitting
Place the Adjustable Cutting Guide onto
the Movable Cutting, Table Ruler/Stop
and tighten the retaining thumbscrew
Install the Splash Guard
onto the Blade Guard
(B)
1
(B)
(B)
(C)
Slide Cooling Flow Adjusting
Clamp onto the Cooling
Transfer Tube