Blade Dressing - MK Diamond Products MK-370 EXP Owner's Manual & Operating Instructions

MAINTENANCE AND TROUBLESHOOTING

4. Blade Dressing

Like most cutting instruments, a diamond blade performs best when it is dressed. Over time and use, diamonds
on the outer edge of the blade will become smoothed or "glazed" over.
This will reduce grinding efficiency and may cause the blade to "wander" or bend giving the illusion of an
alignment problem. When this occurs, the blade will need to be dressed.
The diamond blade can be dressed using the MK Dressing Stick (part number 152792) and by following the
steps below.
(A)
Setup the MK-370 EXP
for operation (See Setup,
Adjustment and Operation)
(D)
Turn the motor ON
Adjustable
cutting guide
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip
(E)
Verify cooling flow on both
sides of the blade
(G)
Ensure the ON/OFF Switch is
in the OFF position
0
(C)
Position the Dressing Stick
(F)
Cut the Dressing Stick 7 or 8
times to dress the Blade