Spool Pin; Threading - Husqvarna Viking Designer I Usb User Manual

Spool pins
USB
Your Designer I
all types of thread. The main spool pin (a) is
adjustable and can be used in horizontal po-
si tion for normal threads or in vertical position
for extra large spools or threads with special
char acte ris tics.
Horizontal position
Place the spool so that the thread reels counter-
clockwise. There are two spool hold ers on the
spool pin. For narrow thread spools, the small
holder (b) is placed in front of the thread. If you
use large thread spools, the large holder (c) is
placed in front of the thread.
Slide the correct size spool holder in place so
the fl at side is pressed fi rmly against the spool,
with no space between spool holder and spool.
Vertical position
To use the spool pin in its vertical position, pull
the spool pin out towards you. Slide on the lar-
ge spool holder and place a felt pad under the
thread spool. This is to prevent the thread from
reeling off too fast.
Fold up Spool pin
There is also an additional, fold up/down spool
pin (d).
The large spool holder (c) is placed under the
thread. This spool pin is used when winding a
bob bin from a second spool of thread or for a
second spool when sewing with a twin needle.
Threading the upper thread
Make sure the presser foot is raised and the
needle is in the up position.
Horizontal spool pin
1. Pull the spool pin out. Place the spool on the
spool pin The thread shall reel counter-clock-
wise. Push the spool pin back in. Hold the
thread near the spool using your right hand.
Use your left hand to bring the end of the
thread in the direction of the arrow.
2. Bring the thread over the pre-tension thread
guide (a) and under the thread guide (b).
Bring the thread over the thread tension discs
(c).
8
Learn your Designer I
has spool pins suitable for
USB
a
c
small holder
large holder
d
c
4.
2.
3.
b
c
a
b
1.