Husqvarna Viking Designer I Usb User Manual page 42

Seam
A seam sews two pieces of fabric together with
a seam allowance that will usually be pressed
open. In most cases edges of the seam allowan-
ce are fi nished with an overcast stitch before
sewing the seam.
Fabric: Woven medium, cut in two.
Touch: Sewing Advisor on the Color Touch
Screen.
Enter: Woven medium on the Fabric screen.
Seam on the Technique screen. (The Sewing
Advisor selects a straight stitch.)
Snap on: Presser foot A as recommended.
Use: Size 80 needle as recommended.
Sew:
• Place fabrics right sides together. Put the fa-
bric in po si tion under the presser foot. Line
up edge with the 5/8" (15 mm) seam guide.
• If you need to adjust fabric, touch Pivot
• Step on foot control. The Sensor Foot lowers
automatically. Stitch a seam halfway down the
fabric.
• Touch Needle stop down
• Stop sewing 5/8" (15 mm) from the end. The
Sen sor Foot raises to the pi vot po si tion with
the needle in the fabric. Pivot fabric. Step on
the foot control, the Sensor Foot lowers auto-
matically. Sew along the edge following the
instructions below.
Reverse
• Touch to lock stitch.
STOP
• Touch to fi nish a stitch and automatically
sew a few stitches in place to tie off and stop.
Touch again to cancel it.
FIX
• Touch to lock the stitches with tiny
straight stitches that sew back and forth slight-
ly.
Thread cutter
• After having fi nished the seam, touch
. The top thread is taken to the back of the
fabric. The thread cutter cuts top and bobbin
threads. The pres ser foot raises to remove fa-
bric.
42
Utility/Garment Sewing
.
.