Husqvarna Viking Designer I Usb User Manual page 60

Bartacks
Secure elastic ends, drapery pleats, belt loops,
and pocket corners with the same look as
ready-to-wear.
Fabric: Woven heavy
Touch: Woven heavy, Menu A, Utility Stitches,
Touch Stitch A32 / A36.
Snap on: Presser Foot B as recommended.
Use: Size 80 needle as recommended
Sew, A32:
• Place fabric in position under presser foot
• Touch Pivot
Step on the foot control, the Sensor Foot
lowers automatically, and stitch.
• Touch . The machine will stop
automatically when the stitch is completed.
The machine will automatically tie-off and cut
the threads.
Sew, A36:
• Place fabric in position under presser foot
• Touch Pivot
Step on the foot control, the Sen sor Foot
lowers automatically, and stich. The machine
will sew a straight stitch until you touch
. Your Designer I
reverse until you touch
USB
Designer I
will then sew a zig zag,
covering the stratight stitches until you touch
.
• The machine will automatically tie-off and cut
the threads.
Belt Loops
Touch: Woven heavy, Menu A, Utility Stitches,
Touch Stitch A13 Three-step zigzag.
Snap on: Presser Foot B as recommended.
Use: Size 80 needle as recommended. Lower the
feed teeth .
Sew:
• Fold in about 3/8" (10mm) on the short ends.
• Place the belt loop on the garment and under
the presser foot.
• Touch Pivot
• Sew a bartack from the outer edge to the cen-
ter of the loop, move the fabric and sew a
new bartack.
60
and adjust fabric if necessary.
and adjust fabric if necessary.
USB
will then sew in
again. Your
and adjust fabric if necessary.
Utility/Garment Sewing