Function Buttons - Husqvarna Viking Designer I Usb User Manual

Function buttons

Stitch Re-start. To start sewing your se-
lected stitch at the beginning of the stitch
without having to re-set any special set-
tings you have made.
STOP is used to conclude a stitch. Your
USB
Designer I
automatically when one stitch sequence
has been completed. The button lights
up when you touch it. STOP is cancelled
when you touch the button again or by
selecting a new stitch. The button light
will go out. The STOP function can be
programmed. It can also be used for one
color embroidery.
FIX is automatically activated when a
stitch is selected or when Thread Cutter
has been used. The button lights up while
FIX function is active. By touching the
lighted button the function can be turned
off. At the beginning – Designer I
a few tie off stitches and goes on with the
selected stitch. Touch FIX while sewing
– Designer I
and stops automatically. The FIX function
can be programmed.
Reverse – your Designer I
reverse when this button is touched. The
button lights up. Designer I
wards when the button is released and the
light goes out. The longest reverse stitch
length is 3mm. For permanent reverse,
touch the button twice in quick succession
before starting to sew. The button will be
lit up and the Designer I
verse until you touch the button again to
cancel.
Needle stop up/down. Touch this button
to move the needle down or up. The set-
ting of the needle stop po si tion is changed
at the same time. You can also tap the
foot control to raise or lower needle.
Touch + SPEED or - SPEED to increase or
decrease the sewing speed. Touch when
not sewing and a Pop-up menu on the
Color Touch Screen indicates the speed
set ting. Touch OK or start sewing and
the pop up goes out. You can change the
speed set ting while sewing but no Pop-up
will appear.
12
fastens the thread and stops
USB
sews a few tie off stitches
USB
sews in
USB
sews for-
USB
sews in re-
USB
Learn your Designer I
All stitches in Designer I
pre-set, recommended sewing speed.
When you select a stitch, Designer I
automatically sets the correct sewing
speed.
USB
sews
START/STOP. Touch this button to run
and stop the machine without the foot
control. Touch START/STOP to begin and
touch again to stop sewing.
Selective Thread Cutter. Touch the but-
ton and Designer I
bobbin threads, raises the presser foot
and the needle to the up po si tion and
activates the FIX function. To cut before
the needle moves to the start position of
next stitch, touch Thread Cutter while the
machine is running. A fl ashing STOP will
indicate that a cut is requested. The Th-
read cutter function can be programmed.
Sensor Foot Lift up and extra lift.
Touch this button and the pres ser foot
and the needle will be lifted to up po-
si tion. Touch the button once more and
the pres ser and foot will raise to ex tra lift
to make it easy to get thick fabric under
the pres ser foot.
Sensor Foot Lift pivot. To simplify pla-
cing the fabric, touch this button. The
pres ser foot will be lowered to pivot po-
si tion.
Sensor Foot Lift down. Touch this but-
ton and the pres ser foot will be comple-
tely lowered and Designer I
holding your work.
USB
have a
USB
USB
cuts the top and
USB
is fi rmly