Usb - Husqvarna Viking Designer I Usb User Manual

Care of your Designer I

USB

Designer I is equipped with two lights, one is
placed to the left of the needle (A) and the other
up to the right (B). Use light bulb de sig ned as
indicated on the front of the machine.
Turn off the main switch.
Changing the light bulb (A)
1. Place the rubber sheath found in the acces-
sory box with its deep hole, marked OUT,
aro und the bulb.
2. Do not turn the bulb, just pull it down to re-
move the bulb.
3. When inserting, place the rubber sheath with
its shallow hole, marked IN, aro und the new
bulb, insert the bulb by pushing it up. Make
sure the bulb is correctly inserted.
Changing the light bulb (B)
1. Remove the plastic guard by pulling slightly
downward.
2. Place the rubber sheath found in the acces-
sory box with its deep hole, marked OUT,
aro und the bulb.
3. Do not turn the bulb, just pull it out to remo-
ve the bulb.
4. When inserting, place the rubber sheath with
its shallow hole, marked IN, aro und the new
bulb, insert the bulb by pushing it up.
5. Replace the plastic guard by inserting the rear
edge and press it into the holder.
110
USB
Care of your Designer I
USB
A
B
3.
OUT
1.
N I
OUT
2.
N I
3.
1.
5.
I N I N
OUT
2.
4.