Table of Contents
Advertisement
Overview
Chapter 3: Front Panel Operation
There are two ways to control Ki Pro: from the front panel or remotely from a web
browser connected via ethernet. This chapter discusses controlling and using Ki Pro
from its front panel. Remote control via browser is discussed in Chapter 4.
In Chapter 2 we covered the panel controls overall, so ensure you read and
understand that material first. Here in this chapter we introduce each of the front
panel's modes and menus as well as Clips and Reels, with procedures for basic use.
First we introduce the two basic front panel modes, TRANSPORT and MENU, followed
by how the SELECT and ADJUST buttons operate in each of these two panel modes.
Select Adjust
The TRANSPORT mode is the default mode—it controls basic PLAY, STOP, FF, REV, REC
and other functions. In the TRANSPORT mode, the Select buttons (up or down) cycle
through the clips in the currently selected storage slot (like previous/next), and the
Adjust buttons allow single-stepping, frame forward or backward. The following
shows the display for the TRANSPORT mode:
Clip SC12BTK1
Reel 212
TRANSPORT Mode
The MENU mode allows you to use the display to view system status, setup or adjust
the system configuration, or modify media settings. Certain parameters set in the
menus are stored in non-volatile memory so that the parameter is remembered
between power cycles, for example: system name and date/time.
To enter the MENU mode to view menus in the display, press one of the 3 MENU
buttons: STATUS, CONFIG, or MEDIA.
D1
47%
01:02:22:14
3
1
1
Advertisement
Table of Contents
