Applying Power; Using Ac Power - AJA KiProRack Installation And Operation Manual

Applying Power

Ki Pro Rack Installation and Operation Manual — Installation
The installation and set up of a Ki Pro is straight-forward. If you'll be controlling the unit
from the front panel buttons and display, it's ready right out of the box. Just cable the
system's audio and video sources, VTR(s), monitors, and audio equipment, mount the Ki
Pro unit as desired, and begin recording. However, if you wish to control Ki Pro from a
web browser, there are additional configuration steps.
Warning!
Since the Mains plug is used as the disconnection for the device, it must remain
readily accessible and operable.
Warning!
Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the device.
Warning!
Unplug this device during lightning storms or when unused for long periods of
time.
Warning!
Do not open the chassis. There are no user-serviceable parts inside. Opening the
chassis will void the warranty unless performed by an AJA service center or licensed
facility. Remove the supplied AC line cord from mains power when moving the unit.
Do not defeat the safety purpose of the grounding-type plug.

Using AC Power

To begin using Ki Pro Rack, plug at least one of the supplied AC line cords into one of
the power sockets on the back of Ki Pro. Then plug the AC line cord into 100-240 VAC
50/60 Hz (the supply is autosensing). For redundancy, connect both AC cords to the Ki
Pro Rack, and connect the cords to separate AC branch circuits. A power switch on the
front panel turns unit power on and off.
29
1