Table of Contents
Advertisement
42
"WARNING Storage Removed" will appear if the media is removed without first
hitting the SLOT button to properly unmount media. In the event this
happens, media immediately re-inserted into the Ki Pro may show clips as "N/
A" and subsequent recordings may not be possible. To resolve this issue,
mount the drive on an Apple computer under Mac OSX, then re-insert the
media. If it does not read properly, you will need to format the media.
"WARNING Backup and Reformat" may appear if media has issues being
mounted by the Ki Pro. As the prompt indicates, it is best to back up the media
by copying it to another drive or disk array and then reformat the media. Some
signs that the media is in a read-only state: even though clips have been
recorded to the media, "N/A" appears in the clip area of the UI, "Loading"
appears in the clip area of the UI but does not eventually load a clip, or hitting
the record button with all settings correctly configured for the Ki Pro does not
result in a recording.
"WARNING Media Unformatted" appears when media was inserted that
contains no filesystem recognized by Ki Pro. Ki Pro recognizes HFS+
filesystems; media with other types of filesystems may appear unformatted to
Ki Pro. Unformatted media or media with other types of filesystems (FAT32,
etc.) may be formatted by the usual means.
"WARNING Change Encode Type" appears because ProResHQ is not supported
on ExpressCard/34. Select another flavor of ProRes (normal, LT or Proxy)
before attempting to record to an ExpressCard/34.
"WARNING Invalid Selection" appears when Ki Pro receives conflicting
configuration requests, such as selecting component in/out "Beta" for HD.
"WARNING Name In Use" appears when an attempt was made to record over a
previously existing clip. This can happen when the take number reaches its
maximum, 999. To resolve it change one of the clip naming parameters to
eliminate the naming conflict.
"WARNING No Video Input" appears when an attempt was made to record but
no video was detected on the input. Check connections and sources to make
sure valid video is being fed to the input selected in 2.1 Video Input.
"WARNING 2 Channel Format" appears when the number of channels selected
in 2.3 Audio Channels is eight, but the selected audio input only supports two
channels. Only SDI supports eight channels.
"WARNING Genlock Missing" appears when 6.1 Genlock has been set to INPUT
or Component Y but there is no signal detected on the chosen genlock input.
"WARNING Genlock Mismatch" appears when 6.1 Genlock has been set to
INPUT or Component Y but the signal detected on the selected genlock input
is incompatible with the video format on the selected video input.
"WARNING Non VFR Format" appears when 1.1 Record type is set to VFR
(variable frame rate), but the video to record is not a valid VFR type. This can
happen because the video format on the selected video input doesn't support
or isn't carrying VFR ancillary data, or the video signal generator is enabled in
41.2 VIDEO SG or 1.4 Input Conversion is enabled.
"WARNING No Clip Name" appears when an attempt was made on a ganged
slave unit to set the clip name to use from a master, but the name was empty.
The custom clip name on the master may be empty.
"WARNING Unsupported Media" appears when a USB-only or SxS card was
inserted into the Ki Pro's ExpressCard/34 slot. These types of media are not
supported by Ki Pro. Choose an ExpressCard/34 from the approved list on
AJA's website.
"WARNING Please Reboot" appears when media was removed without using
the slot button and the Ki Pro cannot continue operating without rebooting.
Advertisement
Table of Contents
