Tc In; Tc Value; Tc Type; Arm Recording - AJA KiProRack Installation And Operation Manual

58

8.0 TC IN

8.1 TC VALUE

8.2 TC TYPE

8.3 ARM RECORDING

8.0 TC IN
This parameter selects the source of timecode start from those available.
TC VALUE (default)
SDI RP188
LTC
TIME OF DAY
RS422
HDMI
Note: Ki Pro Rack only works with HDMI timecode matched to the recording format and
HDMI output: 1080i 29.97 (1080i 59.94) or 1080i 25 (1080i 50). If a 1080p 24 recording on
the camera's internal media with a 1080i 29.97 HDMI output is produced, the Ki Pro Mini
may not respond to HDMI timecode as expected.
8.1 TC VALUE
This parameter selects the starting hour for timecode
00:00:00:00 to
23:00:00:00
(Default: 01:00:00:00)
8.2 TC TYPE
This parameter selects drop frame or non-drop frame timecode.
Note: If the TC In is SDI RP188, LTC, or RS422, the TC Type selection does not apply. TC Type
only applies to the TC Value or the Time of Day value generated by Ki Pro.
NDF (default)
DF
8.3 ARM RECORDING
This parameter selects how recording will begin: either by pressing record button (or
web "Record" button) or via timecode. If starting on timecode, parameters 8.0, 8.1.
and 8.2 must be set to qualify the source and type of timecode.
Note: For TC/REC KEY to operate, a record run timecode with incrementing values and starts/
stops is needed. Freerun timecode does not provide this and is not applicable to the TC/
REC KEY selection.
REC KEY (default)
TC/REC KEY
Use the value specified in parameter 8.1 TC VALUE
Use the timecode read from the embedded RP188
metadata in the SDI input
Use timecode from the LTC input connector
Set TC to "Time of Day" clock (CONFIG parameter 55.6)
RS422 in-point TC value is used for the start value of a
recording (presented only if 35.2 is set to RS422 Only)
Use timecode from HDMI input (Sony cameras only)
when 8.0 is set to TC Value
Use the ADJUST buttons to select a timecode hour.
For example:
01:00:00:00,
Selects Non-drop Frame timecode
Selects Drop Frame timecode
Start when Record button is pressed
Start on Time Code trigger or Record button
.
"
02:00:00:00, etc.