Table of Contents
Advertisement
24
Composite NTSC/PAL Output
One BNC connector (Component Y) supplies composite NTSC or PAL output. Connect
the output BNC to a monitor, or other composite video device. Composite video
signals are D/A (output) converted (10-bit).
Ref Loop
Two looping BNCs allow genlock signal input and output connections. If the
genlock output is unused, it must be terminated using a 75-ohm termination
cap. When the output connects to downstream equipment, the last piece of
equipment in the series must be terminated in 75 ohms.
LTC Timecode Input And Output
Two BNCs provide connections to the house LTC timecode generator or source.
Connections are high impedance. One BNC is for input and the other for
output. Note: the Ki Pro LTC output does not provide output during EE or
recording operations; the output is only for use during playback, as might be used for
dubbing content to another device with matching timecode. For timecode to
multiple Ki Pro units, the use of a timecode generator and a timecode distribution
amplifier is recommended.
AES Digital Audio Inputs and Outputs
AES digital audio connections consist of four BNC input
connectors, two channels per connector (1/2, 3/4, 5/6, 7/8). AES
outputs also consist of four BNC connectors with the same two
channels per connector.
Analog Audio 2-Channel Balanced Input and Output
Four XLRs, 2 female for input and 2 male for output, provide
2 channels of balanced audio. Audio is high-quality 24-bit
A/D input and D/A output at 48kHz. Level adjustments are
made via software. Software level adjustments for analog
audio (parameter 4.1) apply to balanced audio (XLR).
Advertisement
Table of Contents
