Icmp Commands - Allied Telesis AT-9108 Manual

ICMP Commands

ICMP Commands
Command
config irdp <mininterval> <maxinterval>
<lifetime> <preference>
config irdp [multicast | broadcast]
disable icmp redirects {vlan <name>}
disable icmp unreachables {vlan <name>}
disable icmp useredirects
disable irdp {vlan <name>}
enable icmp redirects {vlan <name>}
enable icmp unreachables {vlan <name>}
enable icmp useredirects
enable irdp {vlan <name>}
unconfig icmp
unconfig irdp
20
Description
Configures the router advertisement message timers, using seconds.
Specify:
mininterval — The minimum amount of time between
router advertisements. The default setting is 450 seconds.
maxinterval — The maximum time between router
advertisements. The default setting is 600 seconds.
lifetime — The default setting is 1,800 seconds.
preference — The preference level of the router. An ICMP
Router Discover Protocol (IRDP) client always uses the router
with the highest preference level. Change this setting to
encourage or discourage the use of this router. The default
setting is 0.
Configures the destination address of the router advertisement
messages. The default setting is multicast.
Disables the generation of ICMP redirects on one or all VLANs.
Disables the generation of ICMP unreachable messages on one or all
VLANs.
Disables the changing of routing table information when an ICMP
redirect message is received.
Disables the generation of router advertisement messages on one or
all VLANs.
Enables generation of ICMP redirect messages on one or all VLANs.
The default setting is enabled.
Enables the generation of ICMP unreachable messages on one or all
VLANs. The default setting is enabled.
Enables the modification of route table information when an ICMP
redirect message is received. The default setting is disabled.
Enables the generation of ICMP router advertisement messages on
one or all VLANs. The default setting is enabled.
Resets all ICMP settings to the default values.
Resets all router advertisement settings to the default values.