Qos Commands - Allied Telesis AT-9108 Manual

QoS Commands

Command
config ipqos [add | delete]
<dest_ipaddress>/<mask_length> [qosprofile
<qosname> | blackhole]
config ipqos [add | delete] [tcp | udp | other |
all] <ip_dest_addr>/<mask_length> {l4-
dstport <tcp/udp_port_number>}
{<ip_src_address>/<mask_length>} {l4-
srcport <tcp/udp_port_number>} [qosprofile
<qosname> | blackhole]
config qosmode [ingress | egress]
config qosprofile <qosname> {minbw
<percent>} {maxbw <percent>} {priority
<level>}
create qosprofile <qosname>
delete qosprofile <qosname>
disable isq vlan <name>
disable qosmonitor
enable isq vlan <name>
enable qosmonitor {port <port>}
show qosprofile {<qosname>}
AT-9108, AT-8518, AT-8525, and AT-8550 User's Command Guide
Description
Adds or deletes a QoS profile (short form).
Adds or deletes a QoS profile (long form).
Changes the QoS mode to ingress mode or egress mode.
Configures a QoS profile. Specify:
minbw — The minimum bandwidth percentage guaranteed
to be available to this queue. The default setting is 0.
maxbw — The maximum bandwidth percentage this queue is
permitted to use. The default setting is 100.
priority — The service priority for this queue. Settings
include low, normal, medium, and high. The default setting is
low. Available only in egress mode.
Creates a QoS profile. The default values assigned to a created QoS
profile are
Minimum bandwidth — 0%
Maximum bandwidth — 100%
Priority — low
Deletes a QoS profile.
Disables ISQ on a VLAN.
Disables the QoS monitoring capability.
Enables ISQ on a per-VLAn basis. If the FDB aging timer is shorter
than 3,000 seconds, this command automatically changes the FDB
aging timer to 3,000 seconds.
Enables the QoS monitoring capability on the switch. When no port is
specified, the QoS monitor automatically samples all the ports. Error
messages are logged to the syslog if the traffic exceeds the
parameters of the QoS profile(s). The default setting is disabled.
Displays QoS profile information.
13