Port Commands - Allied Telesis AT-9108 Manual

Port Commands

Port Commands
Command
config mirroring add [mac <mac_address> |
vlan <name> | port <port> | vlan <name> port
<portlist>]
config mirroring delete [mac <mac_address> |
vlan <name> | port <port> | vlan <name> port
<portlist> | all}
config ports <portlist> auto off {speed [10 |
100]} duplex [half | full]
config ports <portlist> auto on
config ports <portlist> qosprofile <qosname> Configures one or more ports to use a particular QoS profile.
disable learning port <portlist>
disable mirroring
disable port <portlist>
disable sharing <master_port>
disable smartredundancy <portlist>
enable learning port <portlist>
enable mirroring to <port>
enable port <portlist>
enable sharing <master_port> grouping
<portlist>
enable smartredundancy <portlist>
restart port <portlist>
show mirroring
show ports {<portlist>} collisions
show ports {<portlist>} configuration
show ports {<portlist>} info
show ports {<portlist>} packet
8
Description
Adds a single mirroring filter definition. Up to eight mirroring
definitions can be added. You can mirror traffic from a MAC address,
a VLAN, a physical port, or a specific VLAN/port combination.
Deletes a particular mirroring filter definition, or all mirroring filter
definitions.
Changes the configuration of a group of ports. Specify the following:
auto off — The port will not autonegotiate the settings.
speed — The speed of the port (for 10/100 Mbps ports only).
duplex — The duplex setting (half- or full-duplex).
Enables autonegotiation for the particular port type; 802.3u for
10/100 Mbps ports or 802.3z for Gigabit Ethernet ports.
Disables MAC address learning on one or more ports for security
purposes. If MAC address learning is disabled, only broadcast traffic,
EDP traffic, and packets destined to a permanent MAC address
matching that port number, are forwarded. The default setting is
enabled.
Disables port-mirroring.
Disables a port. Even when disabled, the link is available for
diagnostic purposes.
Disables a load-sharing group of ports.
Disables the smart redundancy feature. If the feature is disabled, the
switch changes the active link only when the current active link
becomes inoperable.
Enables MAC address learning on one or more ports. The default
setting is enabled.
Dedicates a port to be the mirror output port.
Enables a port.
Defines a load-sharing group of ports. The ports specified in
<portlist> are grouped to the master port.
Enables the smart redundancy feature on the redundant Gigabit
Ethernet port. When the Smart Redundancy feature is enabled, the
switch always uses the primary link when the primary link is
available. The default setting is enabled.
Resets autonegotiation for one or more ports by resetting the
physical link.
Displays the port-mirroring configuration.
Displays real-time collision statistics.
Displays the port configuration.
Displays detailed system-related information
Displays a histogram of packet statistics.